Activa Tyre Pressure: Front, Rear and Pillion PSI
Activa tyre pressure is 22 PSI at the front and 29 PSI at the rear for one rider. With a pillion, raise only the rear tyre to 34-36 PSI. Check cold, before you ride, and read the sticker or manual on your own scooter first.
On this page

Activa tyre pressure is 22 PSI at the front and 29 PSI at the rear when you ride alone. With a pillion, raise the rear tyre to 34-36 PSI and leave the front where it is. These numbers fit the Activa 110, the Activa 125 and the older 3G, 4G and 5G models.
The figures matter more than most riders expect. An Activa runs small 10-inch and 12-inch wheels, so a few PSI of error changes the ride quickly. Too little air makes the steering heavy and wears the tyre edges. Too much air shrinks the contact patch and cuts grip on wet roads. This guide gives you the exact numbers, a model-wise chart, unit conversions and a two-minute routine to check pressure yourself.
Key takeaways
- Solo: 22 PSI front, 29 PSI rear.
- Pillion or heavy luggage: 22 PSI front, 34-36 PSI rear.
- Check pressure when the tyres are cold, ideally before the first ride of the day.
- The front tyre stays at 22 PSI whatever the load.
- Tyres lose a little air every month, so check every two weeks.
Activa tyre pressure chart by model
Honda lists the tyre sizes for every current Activa on its India specification pages. The pressure figures below come from published manual data that tyre makers and spec sites quote. They agree on 22 and 29 PSI. However, sources differ by about 2 PSI for the pillion setting, so the table shows a range.
| Model | Front tyre | Rear tyre | Front PSI | Rear PSI (solo) | Rear PSI (pillion) |
|---|---|---|---|---|---|
| Activa 110 (current) | 90/90-12 54J | 90/100-10 53J | 22 | 29 | 34-36 |
| Activa 125 (current) | 90/90-12 54J | 90/100-10 53J | 22 | 29 | 36 |
| Activa 3G, 4G, 5G | 90/100-10 | 90/100-10 | 22 | 29 | 34-36 |
All of these tyres are tubeless. Also, your scooter’s own label or owner’s manual always overrides a chart on a website, including this one. Honda may revise a figure for a new model year.
How to check Activa tyre pressure at home
A decent gauge costs a few hundred rupees and pays for itself in tyre life. Follow these steps:
- Park the scooter on level ground and let the tyres cool for at least two hours, or check before the first ride.
- Unscrew the valve cap and keep it somewhere safe.
- Press the gauge firmly onto the valve until the hissing stops.
- Read the figure and compare it with the chart above.
- Add air in short bursts, or press the valve pin to release some.
- Refit the valve cap, because it keeps dust and moisture out of the valve.
Petrol pump gauges often drift with age. Therefore, a personal gauge gives you a steadier reference. If a pump reading and your gauge disagree by more than 2 PSI, trust the gauge you have checked against a second one.
PSI, bar, kPa and kgf/cm² for Activa pressures
Some manuals print kPa or kgf/cm², while pumps show PSI or bar. Use this table to move between them. For other values, try the PSI to bar converter.
| PSI | bar | kPa | kgf/cm² |
|---|---|---|---|
| 22 | 1.52 | 152 | 1.55 |
| 29 | 2.00 | 200 | 2.04 |
| 34 | 2.34 | 234 | 2.39 |
| 36 | 2.48 | 248 | 2.53 |
What happens when Activa tyre pressure is wrong
Pressure errors rarely cause drama on the first day. Instead, they build up slowly, which is why many riders miss them.
| Condition | What you notice | What it does to the tyre |
|---|---|---|
| 5 PSI or more too low | Heavy steering, slow turn-in, wobbly feel in corners | Edges wear fast and heat builds up inside the tyre |
| Correct | Light steering, even braking, stable at city speeds | Even wear across the tread |
| 5 PSI or more too high | Hard ride, skittish on wet or painted surfaces | Centre of the tread wears first, and grip drops |
Low pressure also raises rolling resistance. As a result, the scooter needs more throttle for the same speed, and mileage dips.
Pillion, luggage and highway riding
A pillion adds weight over the rear wheel. Consequently, the rear tyre needs more air to hold its shape. The front tyre carries less of that extra load, so it stays at 22 PSI.
Follow these rules:
- Pillion or a heavy bag: set the rear to 34-36 PSI before you leave.
- Back to solo riding: return the rear to 29 PSI. Riding solo at 36 PSI makes the scooter bounce over potholes.
- Long highway runs: start at the correct cold figure. Do not add extra air in advance, because the tyre heats up and gains pressure by itself.
Heat, rain and tubeless tyres
Air expands when it warms. As a rule of thumb, tyre pressure moves about 1 PSI for every 6 °C change in air temperature. A scooter parked in a Delhi winter at 5 °C and a June afternoon at 45 °C therefore differs by roughly 5-6 PSI. Check more often when the season turns.
Riding also warms the tyre. A tyre that read 29 PSI cold may show 31 PSI after a long ride. That is normal. Never release air from a warm tyre to hit the cold figure, or it will end up too low once it cools.
The Activa runs tubeless tyres, which hold air well and lose it slowly through a small puncture. Meanwhile, a slow leak can hide for days. If one tyre keeps losing more than 2 PSI a week, check the valve and look for a nail. Our guide on tubeless vs tube tyres explains why a tubeless tyre gives you time to react.
Common Activa tyre pressure mistakes
- Using the same pressure at the front and rear. The rear carries more weight, so it needs more air.
- Checking right after a ride, when the tyre is warm.
- Trusting the “feel” of the tyre. A tubeless tyre can look fine at 20 PSI.
- Filling to the maximum figure printed on the sidewall. That number is a tyre limit, not a riding recommendation.
- Forgetting the valve cap.
Tools and related guides
The right pressure depends on the right tyre size. Use the tyre size decoder to read the numbers on your sidewall. To see which tyres fit and what they cost, read our Activa tyre price guide. You can also pick your vehicle in the tyre pressure finder on the homepage, or browse every guide in the tyre pressure category.
FAQs
What is the correct Activa tyre pressure?
The correct Activa tyre pressure is 22 PSI at the front and 29 PSI at the rear for one rider. With a pillion, the rear goes up to 34-36 PSI while the front stays at 22 PSI.
What is the Activa 6G tyre pressure?
The Activa 6G, now sold as the Activa 110, uses the same figures: 22 PSI front and 29 PSI rear when solo. The tyres are tubeless, with a 90/90-12 front and a 90/100-10 rear.
What is the Activa 125 tyre pressure with a pillion?
Published charts for the Activa 125 list 36 PSI at the rear with a pillion and 22 PSI at the front. Check the label on your scooter, because Honda can update figures between model years.
Should I check Activa tyre pressure when the tyres are hot?
No. Hot tyres read 1-2 PSI high, and that hides a real shortfall. Check after the scooter has rested for two hours, or before the first ride of the day.
How often should I check Activa tyre pressure?
Check every two weeks, and before any long trip or heavy load. Tubeless tyres lose small amounts of air through the rubber, so a regular check catches slow leaks early.
Is 30 PSI too much for the Activa front tyre?
For solo riding, yes. The front is set at 22 PSI. Running 30 PSI makes the ride harsh and reduces grip, especially on wet roads, so stay near the recommended value.
Keep your Activa tyre pressure right every fortnight
Set 22 PSI at the front and 29 PSI at the rear, then add 5-7 PSI at the rear when you carry a pillion. Buy a simple gauge, check the tyres cold, and note the readings once a fortnight. That habit protects your tyres, keeps the steering light and saves a little fuel. When you need new tyres, check the size first and then compare brands before you buy.
Check your vehicle's own label or manual. DailyPress is independent and not affiliated with any maker, tyre brand or government body.